Walkthrough model worfklow reuse

From Dynamo
Revision as of 05:14, 17 August 2016 by Daniel Castaño (talk | contribs)
Jump to navigation Jump to search

This walkthrough shows how to reuse the geometric computations performed on a single model onto a larger set of models.

We can use a synthetic tomogram containing different tubular structures. In this catalogue, we open the tomogram with dtmslice, and then define a filament model following the usual procedure, so that we end up with a single model containing a set on points.

We will now define a workflow, i.e., a method of converting points into crop_points.

We open the workflow editor of the active model, and start operating the steps, checking graphically the result of each parameter selection. We create first a backbone, selecting the interval between backbone elements.

Creation of the backbone

And check how the results looks like:

right click to get the plotting options of a step
created backbone traversing the points

We then proceed for the next step: selection of the interval (in pixels) between two consecutive crop points.

Selection of interval between crop points

And check again the results:

File:ReuseWorkflowSketchPlotOrder.png
right click to get the plotting options of a step
File:ReuseWorkflowSketchPlot.png
created backbone traversing the points