Difference between revisions of "Table column convention"

From Dynamo
Jump to navigation Jump to search
(Created page with "Category:Table Category:Table rows")
 
Line 1: Line 1:
 +
 +
=Column 1: Tag=
 +
Identifies the particle number.
 +
 +
=Column 2: align=
 +
0 or 1
 +
Used when a table is fed into ''Dynamo''as initial table for an alignment project.
 +
Value 1 tells ''Dynamo''  that the particle is to be used during an alignment project, values 0 skips the particle.
 +
{t|hola}
 +
 +
 +
=Column 10: ftype=
 +
Describes the fraction of the Fourier space covered by the particle.
 +
0 or 'full'
 +
1 or 'single'          beam along z, tilt around y
 +
2 or 'singlex'          beam along z, tilt around x
 +
3 or 'cone',            beam along z
 +
4 or 'double', 'dual'  beam along z, tilts around y and x
 +
5 or 'custom'
 +
6 or 'tilt_z_beam_y'    beam along y, tilt around z
 +
7 or 'tilt_x_beam_y'    beam along y, tilt around x
 +
 +
=Columns 24-26: position in tomogram =
 +
Given in pixels.
 +
 
[[Category:Table]]
 
[[Category:Table]]
 
[[Category:Table rows]]
 
[[Category:Table rows]]

Revision as of 08:53, 8 April 2016

Column 1: Tag

Identifies the particle number.

Column 2: align

0 or 1 Used when a table is fed into Dynamoas initial table for an alignment project. Value 1 tells Dynamo that the particle is to be used during an alignment project, values 0 skips the particle. {t|hola}


Column 10: ftype

Describes the fraction of the Fourier space covered by the particle. 0 or 'full' 1 or 'single' beam along z, tilt around y 2 or 'singlex' beam along z, tilt around x 3 or 'cone', beam along z 4 or 'double', 'dual' beam along z, tilts around y and x 5 or 'custom' 6 or 'tilt_z_beam_y' beam along y, tilt around z 7 or 'tilt_x_beam_y' beam along y, tilt around x

Columns 24-26: position in tomogram

Given in pixels.