Scripted creation of a project in the Linux command line
It is possible to fully run Dynamo outside of Matlab AND the Dynamo standalone, as described standalone#For independent commands
Here we show how to create from scratch a project.
We then create a single script where we write all the commands that we would use interactively to create a project. Use any editor in your system to open a file, let's call it createProject.sh, and input the lines:
dynamo_vpr prtest
dynamo_vpr_put prtest -data ttest/data
dynamo_vpr_put prtest -template ttest/template.em
dynamo_vpr_put prtest -table ttest/initial.tbl
dynamo_vpr_put prtest -mask ttest/mask.em
dynamo_vpr_put prtest -cmask ttest/mask.em
dynamo_vpr_put prtest -fmask ttest/fmask.em
dynamo_vpr_put prtest -smask ttest/mask_smoothing.em
dynamo_vpr_put prtest -ite_r1 2
dynamo_vpr_put prtest -ca_r1 360
dynamo_vpr_put prtest -cs_r1 45
dynamo_vpr_put prtest -dim_r1 32
dynamo_vpr_put prtest -destination standalone
dynamo_vpr_check prtest
dynamo_vpr_unfold prtest
Now, you can run this script in a Linux shell (provided you have standalone#Activating the standalone Dynamo in it)