Membrane models

From Dynamo
Revision as of 15:51, 1 February 2017 by Daniel Castaño (talk | contribs) (Created page with "The input of a membrane model is a set of points defined typically in several z-slices of a tomogram. Through the workflow specific for this model geometry, ''Dynamo'' will cr...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

The input of a membrane model is a set of points defined typically in several z-slices of a tomogram. Through the workflow specific for this model geometry, Dynamo will create a smooth continuous surface that represents the membrane. The output is a set of crop points and orientations. Each orientation will point in the direction of the outwards normal. The membrane model needs to have a center defined, which is merely used to defined the laterality of the surface (which side is "inward" and which side is "outward" )

Workflow description

  1. Creation of control points.
  2. Creation of a supporting mesh
  3. Refinement of the supporting mesh
  4. Creation of the cropping mesh


Workflow on the command line