GPU identifiers

The GPUs accessible by your system in an interactive session (i.e., assuming you can directly ssh onto the node where the GPUs are installed) can be shown with nvidia-smi.

Remember that some GPUs are dual devices. A single NIVIDIA K80 will show as two different devices, with two different integer numbers.

Setting the identifiers

You need to make certain that the identifiers that you pass to the project are correct. During unfolding, Dynamowill not check that the device numbers are correct!

On the GUI

In the dcp GUI go to the computing environment GUI. In the GPU panel there is an edit field for the gpu identifiers.

Through the command line

The parameter is called gpu_identifier_set (short gpus). You can set it into a project using dvput, for instance:

dvput myProject gpus [0,1,2,3]

Environment variable

In some rare systems, you might to be required to manually set the environment variable CUDA_​VISIBLE_​DEVICES to the device numbers that you already selected inside Dynamo.