Search results

Create the page "Limiting shifts" on this wiki! See also the search results found.

• Fourier acceleration
  ...is benefitial compared to direct space computation, even if only very few shifts have to be tested, as a comparison of template and data will generally requ
  2 KB (242 words) - 10:38, 18 April 2016
• Shift limits
  The shift limiting policy is governed by two parameters: the extent of the allowed limit itsel *0: no shift limiting policy
  1 KB (245 words) - 10:13, 26 October 2016
• Example data sets
  * Be careful when limiting the shifts.
  885 bytes (127 words) - 18:34, 2 May 2016
• Multilevel refinement
  ...e previously stored maximum for the full set of angles, this angle and the shifts where the cc maximum is located are set as best aligning parameter, and the
  5 KB (786 words) - 10:35, 27 October 2017
• Starters guide (EMBO2021)
  ...is stored in tables. Each particle has an entry in the table that contains shifts and rotations to describe its orientation (by default these values are init ...mated center (if shifts limiting way is 2). The previous estimates for the shifts and rotations are taken from input tables and are updated at the end of eac
  15 KB (2,422 words) - 16:17, 13 September 2021
• Starters guide (workshop version)
  ...is stored in tables. Each particle has an entry in the table that contains shifts and rotations to describe its orientation (by default these values are init ...mated center (if shifts limiting way is 2). The previous estimates for the shifts and rotations are taken from input tables and are updated at the end of eac
  15 KB (2,427 words) - 19:27, 3 September 2021
• Starters guide
  ...n about the particles in dynamo tables: for each particle a table contains shifts and rotations to bring the particle to the average (by default these values ...mated center (if shifts limiting way is 2). The previous estimates for the shifts and rotations are taken from input tables and are updated at the end of eac
  24 KB (3,775 words) - 16:39, 6 September 2021